SETUP IS EASY
Overland Hammocks were designed for quick, simple setup to get you relaxing as quick as possible. We eliminated all the hardware that can get lost or break and have attached everything to the hammock so you only have to pick your trees, fasten the tree straps around the tree and tighten the adjustable suspension.
The hammock is hung between two trees using the attached tree straps. Optimal hammock hanging will occur by selecting two 10+ inch diameter trees approximately 15-20 feet apart.
1. WRAP AROUND TREE

WRAP THE STRAPS
Pull one end of webbing and wrap around first tree as high as you can reach. Position stopper knot under strap.

FASTEN THE HITCH
Loosen the loop and wrap the stopper knot over the strap and tuck back through the loop.

CINCH TO TIGHTEN
Cinch down the loop to secure the stopper knot and pull down on the webbing.
2. ADJUST TO FIT
TO MOVE TOWARDS TREE / RAISE HAMMOCK
Hold point where the grey tail comes out of the dark cord and pull tail towards tree.
To set in place, run your fingers down cord towards hammock until outside layer is tight.

TO MOVE AWAY FROM TREE / LOWER HAMMOCK
Hold knot at the other end of the dark cord and pull the line going to the hammock.
To set in place, run your fingers up cord towards the tree until the outside layer is tight.