QUICK AND EASY SETUP

Overland Hammocks were designed for quick, simple setup to get you relaxing as quick as possible. We eliminated all the hardware that can get lost or break and have attached everything to the hammock so you only have to pick your trees, fasten the tree straps around the tree and tighten the adjustable suspension. 

The hammock is hung between two trees using the attached tree straps.  Select two 10+ inch diameter trees approximately 15-20 feet apart.

WRAP AROUND TREE

 
 
setup1.jpg

WRAP THE STRAPS

Pull one end of webbing and wrap around first tree as high as you can reach. Position  stopper knot under strap.

setup2.jpg

FASTEN THE HITCH

Loosen the loop and wrap the stopper knot over the strap and tuck back through the loop.

SETUP3.jpg

CINCH TO TIGHTEN

Cinch down the loop to secure the stopper knot and pull down on the webbing.

 

ADJUST TO FIT

 
Move Towards Tree

TO MOVE TOWARDS TREE / RAISE HAMMOCK

Hold point where the black plastic tipped tail comes out of the bury and pull tail towards tree. 

To set in place, run your fingers down cord towards hammock until outside layer is tight.

setup2.jpg

TO MOVE AWAY FROM TREE / LOWER HAMMOCK

Hold knot at the other end of the bury and pull the line going to the hammock. 

To set in place, run your fingers up cord towards the tree until the outside layer is tight.

 
 

LAY BACK AND RELAX